NeuroTrac Pelvitone

The NeuroTrac PelviTone Pelvic Exerciser will help with a wide variety of continence problems and is widely used by therapists around the world. If you suffer from any type of continence problem, the Continence Pelvic Exerciser will be able to help. Sit down, relax and ease your continence problems away! The NeuroTrac PelviTone uses neuromuscular electrical stimulation (NMES) to trigger your muscles into action. It has all of the same features as the NeuroTrac Continence, as well as advanced multi-phase programmes where treatment is split into time phases with different stimulation parameters and stronger symmetrical stimulation with the reduced Pulse Width: 50 � 330 ?S. The NeuroTrac PelviTone Pelvic Exerciser is an advanced and modern digital exerciser it will help you with a wide variety of continence problems with 11 pre-set programmes it has a programme for all women. Ultra effective it works deep within the muscles of the pelvic floor to treat a wide variety of continence problems. If you suffer from any type of incontinence problem, the PelviTone will be able to help. There are programmes specifically designed to individually treat stress, mixed and urge incontinence, pelvic pain, and lack of sensation.

In stock

SKU

8-TM003

Be the first to review this product

£138.00 £115.00

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Description

Dual channel: individually isolated circuits. Amplitude: 0-90 mA into 500 Ohm load; actual mA will tend to be less than indicated due to electrode impedance: at 1000 Ohms load (Electrodes in poor condition) the maximum will be limited to 86 mA, at 1500 Ohms load the maximum will be limited to 65 mA. Type: Constant current, maximum output voltage 180 Volts +10 / -30 Volts Waveform: Symmetrical, rectangular bi-phasic with zero DC current. Selectable pulse width: 50 ?S � 330 ?S [2% accuracy]. Pulse Rate selection: in the continuous mode 2 � 100 Hz [2% accuracy]. Time duration of the treatment selectable: 1 minute to 90 minutes. Low Battery Indicator: If the battery goes below 6.9 volts +/- 0.2 volts the battery symbol will flash on/off once every second. Open Electrode Detect: If an open circuit is detected at the output of channel A or B the output current will be reset at zero. Ramp up time 0.1 � 9.9 seconds. If the battery voltage is below 6.6 (+/- 0.2) volts the unit will not turn on. Physical dimensions: 134 x 69 x 29.7 mm. Weight: 0.18 KG with battery. Environmental Conditions for use: +5 to +40 degrees Centigrade. 0-90% Humidity. Environmental conditions for storage & transport: -25 to +70 degrees Centigrade. 0-90% Humidity.